Hundreds of stylish bathroom model rooms, irresistible decoration fun, no matter the size can refer to the case, there must be a favorite.
Six points of consideration in bathroom construction
First, the threshold
The threshold is a level that prevents water from escaping from the bathroom. Its design and construction points are:
1) The upper surface of the sill should be inclined to the inside of the bathroom so that the water drops can smoothly slide to the inside of the bathroom;
2) The threshold should be the same width as the door frame, and the door frame should be the same thickness as the wall, so that there will be no big in and out when laying the floor tiles, and the chance of breaking the door will be relatively reduced.
Second, the ground waterproof
There are many kinds of waterproof materials, and water repellents are more commonly used at present. When laying the waterproof layer, it should be laid about 20 cm above the wall, at least not below the height of the threshold. When the floor has a reserved pipe, the waterproof layer also needs to enclose the reserved pipe. After the floor is waterproof and dry, it must be immediately grounded with cement mortar or protective measures to prevent damage to the waterproof layer.
Third, the floor tile laying
There are three essentials for laying bricks:
1) There should be about one percent of the slope of the discharge, and the slope faces the floor drain;
2) The joints of the floor tiles should be the same thickness and aligned with the wall brick joints;
3) When the front wall of the bathtub is tiled, the floor tiles should be attached to the bottom of the wall first, then the bricks should be attached to avoid the breakage.
Fourth, wash the face
Washing the countertop should choose "all body" (that is, the surface material of the countertop and the inner material composition and color are the same). It is not allowed to select a countertop with only one surface of the plastic shell, because the countertop with only the surface rubber shell can not be repaired once it is damaged. (To check whether the table top is "all-body", you can use the light to illuminate from the back at a close distance, and the light-transmitting is the "full body" table). In addition, the joint between the countertop and the washbasin must be filled with a grout to prevent water from seeping from the seam.
Five, toilet
Generally, when installing the toilet, it is customary to use cement mortar to fill the toilet. In fact, this method is wrong. After fixing the toilet in this way, the toilet cannot be disassembled again. If the pipeline is severely blocked, only knock it off. A way to toilet.
Sixth, exhaust fan
Generally, when people build houses, they don't pay much attention to the bathroom ventilation equipment. Most of them just install an exhaust fan. The bad gas in the bathroom can't be discharged outside, it just circulates in the bathroom.
Firefighting supplies
vchomy , https://www.jsvichen.com