[ Chinese wardrobe net ] The wardrobe installation seems to be a complicated process. Only after you understand the specific installation steps and methods, you will feel that the custom wardrobe installation is not as difficult as imagined. Let’s take a look at the Jinan decoration master wardrobe installation. The whole process.
1. Preparation stage
1 Materials are on the scene: more formal furniture manufacturers, when the plates are shipped to the site, there are generally cardboard packaging. After unpacking, check the plates and hardware.
2 Fixing screws: The nails are generally left in the design according to the design. The workers at the site use special tools to fix the screws.
3 Measure the side panel: Since the wardrobe is placed on the wall, the side panel should be sawn off at the position of the skirting. After you have it, look it up and see if it fits.
2, the installation phase
1 Place the bottom plate: The floor placed on the bottom of the wardrobe should be cleaned beforehand, because it will be very troublesome to clean up after installation.
2Fixed frame: Install the side and back panels of the closet according to the grooves on the board, and adjust the position between the boards.
3 Install the top plate: It is best to prepare a climbing stool on the site. The top plate should be lifted up and then fixed with rivets.
4Installing the shelf: Place the shelf in the place where the screws are pre-punched, and then fix it. Pay attention to the fixed position of the shelf and the back and side panels.
5 Fixed door rail: The door rail is installed on the top and bottom of the wardrobe. The alloy material of the door rail is better, light and firm.
6 Install the clothes rail: Fix the rivet in the reserved position and install the clothes rail. Note that the two sides should be balanced.
3. The closing stage
1Installing the door leaf: Two sliding doors should be attached to the position of the guide rail. Fix the door leaf first and then fix the guide rail of the bottom side to avoid the phenomenon that the door leaf falls off in the future.
2 adjustment and improvement: After all the installation, make a "full inspection" on the wardrobe, if there is deviation, adjust it in time.
4, complete the acceptance
Finally, check the wardrobe: Shake the cabinet to see if it is firm and the details are in place.
Linux Face Recognition features
1. The Linux face identification device status can be set through the TCP/IP network, as well as upload and download information; network communication data encryption.
2. Naturalness, the method of Linux access face recognition is the same as the biological characteristics used by humans for individual recognition.3. Temperature Linux face recognition completely non-contact, can avoid bacterial infection, more health and sanitation and temperature measurement.
4. 8 inch Linux face recognition has voice prompt, real human voice prompts whether the face image is verified successfully.
Linux Face Identification Device,8 Inch Linux Face Recognition,Temperature Linux Face Recognition,Linux Access Face Recognition
Guangdong Zecheng Intelligent Technology Co., Ltd , https://www.zecheng-security.com